CleverAutomation.de Posted June 25, 2014 Share Posted June 25, 2014 Hello, I got a Powerbrick LV for testing. Now I'm trying to setup the System with Power PMAC Suite / System Setup. A Motor is added, configuration steps 1-6 are done. In step 7 "Test and Comissision the Motor" in test No.6 ("Open loop test") the automatic test fails and the manual test shows this error: "File upload Failed. File Size is Zero" Thank you! Link to comment Share on other sites More sharing options...
steve.milici Posted June 27, 2014 Share Posted June 27, 2014 Can you send a screenshot of this error to support@deltatau.com? Link to comment Share on other sites More sharing options...
CleverAutomation.de Posted July 4, 2014 Author Share Posted July 4, 2014 I found, that this error occurs, if pAbortAll is not set to 0 (with unconnected abort). So, I wrote for my tests this line in pp_startup.txt: pAbortAll = 0; Link to comment Share on other sites More sharing options...
steve.milici Posted July 10, 2014 Share Posted July 10, 2014 The "Debug Messages" indicates that you are getting a FatalFeLimit fault. This results in no data being gathered. Follow the suggestion to make this limit "not too conservative". This should clear up the issue. Link to comment Share on other sites More sharing options...
Recommended Posts