steveneads Posted May 13, 2015 Share Posted May 13, 2015 I've had a few occasions recently where PowerPMAC has been behaving very oddly after downloading code and it's been apparent that code is not running correctly. My remedy has been to do a "clean" and re-download and save the code, and then to issue a $$$. On several occasions the reset has not happened and eventually the message "PowerPMAC reset failed" appears. What is happening? The only remedy then seems to be to repower the system - and then things seem to work normally again. Any ideas? Link to comment Share on other sites More sharing options...
Omron Forums Support Posted May 13, 2015 Share Posted May 13, 2015 Do you have any C programs that run at powerup? Do you have any MACRO-related commands saved in the header files (filetype .pmh) in the Global Includes folders? Link to comment Share on other sites More sharing options...
steveneads Posted May 15, 2015 Author Share Posted May 15, 2015 Yes, we have a number of background C programs and a CPLC which is started by PLC 1 which also runs on power up. There are no MACRO-related commands. Link to comment Share on other sites More sharing options...
Omron Forums Support Posted May 15, 2015 Share Posted May 15, 2015 It varies, but sometimes customers can cause problems for themselves using C depending on their ability level. Could you post the C programs here so I can check if they're safe? Also, what did you mean earlier, exactly, that the code wasn't running correctly? Link to comment Share on other sites More sharing options...
Recommended Posts