hongchinlin_992x Posted April 13, 2011 Share Posted April 13, 2011 The IDE hangs at the step of “Please Wait while mapping Power PMAC variables” after a build command is initiated. Any suggestion? Link to comment Share on other sites More sharing options...
Omron Forums Support Posted April 13, 2011 Share Posted April 13, 2011 The IDE hangs at the step of “Please Wait while mapping Power PMAC variables” after a build command is initiated. Any suggestion? Please give the IDE version and Firmware version? Atul Link to comment Share on other sites More sharing options...
hongchinlin_992x Posted April 13, 2011 Author Share Posted April 13, 2011 IDE: 1.3.0.20 Firmware: 1.3.0.0 Link to comment Share on other sites More sharing options...
Omron Forums Support Posted April 13, 2011 Share Posted April 13, 2011 IDE: 1.3.0.20 Firmware: 1.3.0.0 I use the same version and do not see the problem. Is it everytime you build ? Thanks, Atul Link to comment Share on other sites More sharing options...
artag Posted April 14, 2011 Share Posted April 14, 2011 I'v had this too, but not consistently. I can kill the IDE, restart, and it will be fine. -adrian Link to comment Share on other sites More sharing options...
gshort Posted April 14, 2011 Share Posted April 14, 2011 Yes, I've seen this issue as well from time-to-time. We had a theory that the IDE was attempting to do web access which was failing causing the hang. It does largely seem to recover although sometimes after several minutes. Link to comment Share on other sites More sharing options...
Recommended Posts