kramrellim Posted January 22, 2014 Share Posted January 22, 2014 NCpro 5.2 running on Win7. Everything seems to work but the program rewind button. Is this button handled through a PLC or is it handled from within the front end Nc program? If it is handled through a plc, which one, were? Can program rewind be activated from a plc if I want to have some event cause a rewind? Mark Link to comment Share on other sites More sharing options...
cncguru Posted February 7, 2014 Share Posted February 7, 2014 NCpro 5.2 running on Win7. Everything seems to work but the program rewind button. Is this button handled through a PLC or is it handled from within the front end Nc program? If it is handled through a plc, which one, were? Can program rewind be activated from a plc if I want to have some event cause a rewind? Mark This is handled in the Reset PLC. The rewind section is towards the end. Link to comment Share on other sites More sharing options...
steve.milici Posted February 10, 2014 Share Posted February 10, 2014 The button sets P988 (REWIND_INIT) the Reset.plc monitors this and performs the following action: @SET_ON(CS_COMMAND3_M,CS_PRG_REWIND). Link to comment Share on other sites More sharing options...
Recommended Posts