Jump to content
OMRON Forums

Clipper drive manual


Recommended Posts

The schematic of the user flags and the EQU outputs on page 28 of the manual does not look correct. As far as I can determine, the EQU outputs and User flags are connected directly to the JMACH2 port, without interface. And I would expect the EQU signals to be TTL level outputs.
Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

This topic is now closed to further replies.

  • Create New...