Jump to content
OMRON Forums

Power Brick Controller Manual


Omron Forums Support
 Share

Recommended Posts

  • 5 months later...
  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

  • 1 year later...
  • 1 year later...

"Do not mix topologies for outputs. They are all either sinking or sourcing per connector (X16 / X17)." p.103 should be X15/X16.

 

Please redraw diagram on p.104 to clarify input and output commons. Typical usage in my experience has been to implement a single topology (i.e. all PNP or all NPN, not split between PNP/NPN inputs and outputs). As it is, descriptions for pins 11/29 on X15/X16 are confusing (COM_EMT and COM_COL imply opposing terminals of a transistor yet both diagrams on p.104 show them connected to the same reference voltage).

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share


×
×
  • Create New...