Jump to content
OMRON Forums

Inductive encoder with CMOS and TTL output


thamwaifoong
 Share

Recommended Posts

Hello guys,

 

i have directly connected a maxon flat motor come with a MILE (inductive incremental encoder) to J3 terminal from turbo pmac clipper board, but there's no position ready. When i changed back to HEDS 5540 avago optical encoder, everything works fine. The conversion type is 1/T extension of incremental encoder. May i know where i did wrong?

 

attached the motor and encoder datasheet.

 

Thanks.

15-342-EN.pdf

Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

The data sheet indicates the encoder output is a TTL compatible signal. This should work with the Turbo Clipper. Verify your wiring is correct. Also check the signal with a scope - maybe the encoder has been compromised and does not produce a signal.

 

As this is a technical support issue please contact our support group for further assistance: support@deltatau.com or +1-818-717-5656.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share


×
×
  • Create New...