Jump to content
OMRON Forums

Transfer cfg file PMAC Lite to PMAC PCI


Recommended Posts

I assumed that I could copy the .cfg file from my 4-axis pmac to my 8 axis one and my channels 1-4 would work the same. This post suggests it should:



Unfortunately it doesn't. As I move the motors by hand I see a correct change in position but when using the jog ribbon I can just feel an occasional small pulse, esp when I hit the Kill All button. Programs don't run at all.


What parameters do you think need changing?

Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

This topic is now closed to further replies.

  • Create New...