andreychip

Thank you.

Thank you. But I asked for the code for ACC-24S3 for boards Power Clipper .

Hi. I wanted to know the order code for ACC-24S3 4-Channel Axis Expansion Stack Board. best regards Andrey.

thank you very much

What to do with the files in the firmware and ppmac.zip sourcediff.zip ?

thank you very much

You can get new firmware on the PowerPmac Clipper controller and the instructions how to sew.

a task manager screenshot

Hello. We have a PowerClipper firmware version 2.0.2.14. Working with PoverIDE version 2.0.3.40 4/21/2015, no problem, attached screenshots . When you install the new PowerClipper version 2.2.0.39 7/16/2016 we had a problem with the configuration EtherChat: 9/9/2016 :9:46 AM - 192.168.10.200, Module - Setup Motor : Error - EtherCAT setup requires a Firmware upgrade to version 2.0.2.210 or newer. Attached screenshots below. best regards.

thank you.

1.What delivery times NC14 in russia? 2.How many axis available for Russia?

I8010=$A78018 //$350B The bit 19 mode switch must be set to 0 if a PMAC-style Servo IC (DSPGATE) is addressed; it must be set to 1 if a PMAC2-style Servo or MACRO IC (DSPGATE1 or DSPGATE2) is addressed. Note that setting bit 19 to 1 changes the second hex digit of the I-variable from 7 to F. TurboSRM page 240. I8010=$AF8018.

Check spindle parameter in the registry NC Pro 2 encoder counts 4096 was installed.

Hi. I can give the manual Power PMAC-NC HMI (PPNC), please?

Thank you.

Hi. Do not prompt, Power PMAC-NC16 works with TURBO CLIPPER ? Thank you!

Hi. You can tell the price Power PMAC NC 14 Software Development Kit (Two Runtime Licenses Included) PPNC-0000000-002-000 for Russia? Thanks.

Thank you for your help

Hi. Where to get these files Files Required for Installation Renish.pmc FANUC to PMAC translated probing routines. Probe.plc Initializes probe, monitors skip signal. Errors.dat Contains text of alarms specific to probing. Dprnt.enu ?

we use PHMI-NC-PRO2. Thanks, at the moment everything is working

Hi ! May specifically describe what this Alarm "(X) Motor on limit"? This type of alarm occurs, when the load on the drive increases .

text message "(X) Motor on limit" Alarm eliminated reduced parameter I117 from 0.2 to 0.1

hi! The problem is that when turning on the details of the function G01 there is an alarm "motor on limit" and stop the drive. What kind of alarm? How to find the cause of this alarm? thank you

Read guide TURBOPMAC_USER_MANUAL and TURBO SRM http://www.deltatau.com/Manuals/Default.aspx example ROTARY buffer Programs0.PMC

see description of ACC-36E http://www.deltatau.com/Manuals/Default.aspx